Via the website I received this. Can anyone comment or is interested in getting bumpers made?
I have an Allard Palm Beach MK 1 and am told the bumpers are Jowett Javelin.Could you confirm this and do you know of or have any spares
Hi Julian,
Probably best if you send us an image of the bumpers required as there are a few variations on the Javelin. The club spares scheme only sells to members of the Jowett Car Club. You may want to try your luck on the JowettTalk forum in the Cars and spares section. You will need to register to post a request.. I think you will find that only used ones are available though that require some fettling and rechroming. There was some discussion of getting some made , but I do not know what transpired
Keith,
Herewith the pics.Both bumpers are 59ins wide and 4ins deep.The starting handle hole may be a “giveaway”
many thanks for any help in identification/replacement
regards
Julian
My Javelin bumper front is 56.5 inches and rear is 58. The width is 4 inches. My rear bumper seems to have holes about in the same place.
I have successfully recovered quite damaged ones with fettling, braze and then re-chrome. They were certainly worse than yours!
However, the cost of doing such is not cheap and getting new ones made might be cheaper.
Perhaps a joint venture between the two clubs?
I will put this conversation on our forum.
IMG_1253.jpg
IMG_1254.jpg
IMG_1255.jpg
untitled.png
You do not have the required permissions to view the files attached to this post.