https://goodson.com/products/crankshaft ... dius-gauge
I am in disbelief that UK crankshaft shops don't have a gauge.
Kings Langley garage meet
-
Keith Clements
- websitedesign
- Posts: 3819
- Joined: Wed Feb 08, 2006 11:22 am
- Your interest in the forum: Jup NKD 258, the most widely travelled , raced and rallied Jowett.
- Given Name: Keith
- Contact:
Re: Kings Langley garage meet
The places I tried were engine builders, not specialist regrinders. The one used by Classic Autos is 50 miles away.
The crank has been measured by Apsley Transmissions and confirms the 2.238 measurement I got except the rear main did have half a thou thinning which I will confirm tomorrow.
I will also measure the journal radius using the two methods.
Harry and I took the engine out of Amy's Jup and replaced it with the engine out of the Leopold Jup that I have re commissioned.
The crank has been measured by Apsley Transmissions and confirms the 2.238 measurement I got except the rear main did have half a thou thinning which I will confirm tomorrow.
I will also measure the journal radius using the two methods.
Harry and I took the engine out of Amy's Jup and replaced it with the engine out of the Leopold Jup that I have re commissioned.
skype = keithaclements ;
Who is online
Users browsing this forum: No registered users and 4 guests