https://goodson.com/products/crankshaft ... dius-gauge
I am in disbelief that UK crankshaft shops don't have a gauge.
Kings Langley garage meet
-
Srenner
- Posts: 556
- Joined: Sat Mar 04, 2006 7:32 am
- Your interest in the forum: Like to look at pictures
- Given Name: Scott
- Location: United States
-
Keith Clements
- websitedesign
- Posts: 3968
- Joined: Wed Feb 08, 2006 11:22 am
- Your interest in the forum: Jup NKD 258, the most widely travelled , raced and rallied Jowett.
- Given Name: Keith
- Contact:
Re: Kings Langley garage meet
The places I tried were engine builders, not specialist regrinders. The one used by Classic Autos is 50 miles away.
The crank has been measured by Apsley Transmissions and confirms the 2.238 measurement I got except the rear main did have half a thou thinning which I will confirm tomorrow.
I will also measure the journal radius using the two methods.
Harry and I took the engine out of Amy's Jup and replaced it with the engine out of the Leopold Jup that I have re commissioned.
The crank has been measured by Apsley Transmissions and confirms the 2.238 measurement I got except the rear main did have half a thou thinning which I will confirm tomorrow.
I will also measure the journal radius using the two methods.
Harry and I took the engine out of Amy's Jup and replaced it with the engine out of the Leopold Jup that I have re commissioned.
You do not have the required permissions to view the files attached to this post.
skype = keithaclements ;
-
Forumadmin
- Site Admin
- Posts: 20648
- Joined: Tue Feb 07, 2006 5:18 pm
- Your interest in the forum: Not a lot!
- Given Name: Forum
21 thou method valve timing
A direct link to the 21 thou method of setting valve timing viewtopic.php?p=46666#p46666