Jowett 10/4 heavy steering
-
nigel jarrett
- Posts: 144
- Joined: Sun Jan 04, 2009 11:58 pm
- Your interest in the forum: Javelin and pre war
- Given Name: Nigel
- Location: TEIGNMOUTH DEVON
Jowett 10/4 heavy steering
Hi all I am interested in purchasing a 1937 10/4 when I tested the car the steering seemed stiff and heavy and tended to wander on the road ,has anyone got any ideas as I am quite keen on the car to go alongside my Javelin
Thank you in anticipation
Thank you in anticipation
have just purchased a javilin and will need all the help i can get
-
k. rogers
- Posts: 480
- Joined: Thu Feb 23, 2006 9:43 pm
- Your interest in the forum: 1933 7hp Kingfisher
1935 7hp Weasel
1928 7hp Sports replica
1952 Bradford special - Given Name: Ken
- Location: Cornwall
Re: Jowett 10/4 heavy steering
Wow, Nigel, that sounds great. It could be someone has attempted to take up freeplay in the steering box by turning the outer sleeve (anti-clockwise) on the column, but may have over done it. The only way is to jack the car up at the front and release the sleeve until the steering is free, then finely adjust. That is of course if it is the problem - I can't think of anything else it might be!
7hp Weasel & Kingfisher
-
nigel jarrett
- Posts: 144
- Joined: Sun Jan 04, 2009 11:58 pm
- Your interest in the forum: Javelin and pre war
- Given Name: Nigel
- Location: TEIGNMOUTH DEVON
Re: Jowett 10/4 heavy steering
Thanks Ken any help is appreciated as I have no knowledge on pre war cars Yet to make final decision on the car Ann says yes ,we will see
have just purchased a javilin and will need all the help i can get
-
Tony Fearn
- Posts: 1743
- Joined: Thu Feb 09, 2006 5:33 pm
- Your interest in the forum: Early pre-wars. Owner of 1933 'Flying Fox' 'Sarah Jane, and 1934 Short saloon 'Mary Ellen'.
- Given Name: Anthony
- Location: Clayton le Moors, Lancashire, the Premier County in the British Isles!!
Re: Jowett 10/4 heavy steering
Hello Nigel, nice photo of the three of you in the February Jowetteer.
The 10/4s have a different type of steering to the earlier pre-war cars such as mine and Ken's.
This attached scan I've pieced together is from 'The Book of the Jowett and Bradford' by Pitman.
If stiff steering is the only problem then have a go and buy it, it might only be a shim! (-or two)
I don't have an instruction book or illustrated spares catalogue for the 10/4 model, but a request through the mag rather than JowettTalk might just turn up trumps.
I don't know whether there's a register of who owns these four-cylinder cars in the Club, but a telephone call to the Spares Officer might bear fruit. Peter is very knowledgeable.
Best wishes,
Tony. P.S. The old grey cells have been stimulated, and I've remembered that I have a more detailed source for the Marles Weller steering, so here it is:
The 10/4s have a different type of steering to the earlier pre-war cars such as mine and Ken's.
This attached scan I've pieced together is from 'The Book of the Jowett and Bradford' by Pitman.
If stiff steering is the only problem then have a go and buy it, it might only be a shim! (-or two)
I don't have an instruction book or illustrated spares catalogue for the 10/4 model, but a request through the mag rather than JowettTalk might just turn up trumps.
I don't know whether there's a register of who owns these four-cylinder cars in the Club, but a telephone call to the Spares Officer might bear fruit. Peter is very knowledgeable.
Best wishes,
Tony. P.S. The old grey cells have been stimulated, and I've remembered that I have a more detailed source for the Marles Weller steering, so here it is:
You do not have the required permissions to view the files attached to this post.
-
k. rogers
- Posts: 480
- Joined: Thu Feb 23, 2006 9:43 pm
- Your interest in the forum: 1933 7hp Kingfisher
1935 7hp Weasel
1928 7hp Sports replica
1952 Bradford special - Given Name: Ken
- Location: Cornwall
Re: Jowett 10/4 heavy steering
Of course, I was forgetting the 10/4 is a different set up. Might be worth having a word with Geoff, but whatever the problem, I'm sure it can be cured. I'm excited for you both - it would be fantastic to have one of these in our section. Their engines are so smooth! Good luck.
7hp Weasel & Kingfisher
-
nigel jarrett
- Posts: 144
- Joined: Sun Jan 04, 2009 11:58 pm
- Your interest in the forum: Javelin and pre war
- Given Name: Nigel
- Location: TEIGNMOUTH DEVON
Re: Jowett 10/4 heavy steering
Thank you Tony there is a lot of useful information there
have just purchased a javilin and will need all the help i can get
-
Keith Clements
- websitedesign
- Posts: 3968
- Joined: Wed Feb 08, 2006 11:22 am
- Your interest in the forum: Jup NKD 258, the most widely travelled , raced and rallied Jowett.
- Given Name: Keith
- Contact:
Re: Jowett 10/4 heavy steering
Vic Morrison in NZ is your best bet. I had a great drive through the mountains with him in his 4 cylinder. Fantastic car.
I think what you want is in the Gallery or the 10/4 handbook
or Spares List
If there is something you cannot find in the Gallery, then it needs to be in there!
I think what you want is in the Gallery or the 10/4 handbook
or Spares List
If there is something you cannot find in the Gallery, then it needs to be in there!
skype = keithaclements ;
-
David Kemp
- Posts: 628
- Joined: Sun Mar 09, 2008 1:18 pm
- Location: Brisbane ,Australia
Re: Jowett 10/4 heavy steering
Before dismantling steering gear, check all the basics. Are the kingpins greased & in good condition?
Are the grease nipples allowing grease to penetrate? If not you will need arms like Tarzan to steer.
Are the grease nipples allowing grease to penetrate? If not you will need arms like Tarzan to steer.
Good memories of Bradfords.
-
The Bradford man
- Posts: 165
- Joined: Sun Feb 04, 2007 2:54 am
- Your interest in the forum: Jowetts, Subarus, Any thing with a Boxer engine.
- Given Name: James
- Location: CHRISTCHURCH, NEW ZEALAND
Re: Jowett 10/4 heavy steering
My 10 had the Steering box fully rebuilt before I got it. Fantastic to steer and handles very well.
I wish my 8 was so nice in the steering.
I wish my 8 was so nice in the steering.
James~
1953 Jowett Bradford CC truck restoration project
1937 Jowett 10hp
1939 Jowett 8hp
Chris~ RIP
Possibly the only person or one of the few that owned one of every type Bradford at the same time CA,CB,CC,CD.
1935 Jowett 7 Project unfinished.
1953 Jowett Bradford CC truck restoration project
1937 Jowett 10hp
1939 Jowett 8hp
Chris~ RIP
Possibly the only person or one of the few that owned one of every type Bradford at the same time CA,CB,CC,CD.
1935 Jowett 7 Project unfinished.