Bradford Driveshaft

Keith Andrews · Post by **Keith Andrews** » Wed Jan 24, 2007 12:35 am

According to the manual....at one end is an arrow indicating direction of turn...and to pint in the right direction must be fitted at the gearbox tail shaft end....
I have 4 drive shafts and one still in the tar paper...
And cant find an arrow on any

Where is the arrow? a pic would be good.
And if there is no arrow, what other means can one tell which end goes where?
Cheers
Steps

Keith Andrews · Post by **Keith Andrews** » Thu Jan 25, 2007 8:03 pm

'Bump'

For those who dont know what 'bump' is..
This is where a question has been asked, and the problem has still not been sorted...
It brings the thread back to the top, sometimes questions/items can get lost without people seeing them.